Skip to content
Meter box on a St George bungalow with new consumer mains in conduit
Level 2 electrical

Consumer Mains Upgrade St George

Replacing worn and undersized mains between the point of attachment and your meter board, sized for how your home runs now.

Get a free quote

Takes a minute. We'll call you back, usually the same day.

No obligation. Your details stay with us and are never sold or shared.

The consumer mains are the heavy cables that run from where the network attaches to your house to your meter board. In St George, a lot of them were installed when the houses were built: inter-war bungalows in Bexley and Kingsgrove, post-war brick and fibro in Mortdale and Peakhurst, Federation homes around Penshurst and Kogarah. That cable was never meant to carry ducted air conditioning, an induction cooktop, a pool pump and an EV charger at the same time.

What we see in St George homes

The classic St George setup is a bracket on the front or side wall under the eave, a short run of mains inside the wall or eave, and a meter box near the front door or down the side driveway. On many bungalows the mains have been there since the house was first connected. On older homes we still find rubber-insulated cable that has cracked with heat; on 1960s and 70s homes we find smaller PVC cable that works, but runs hot under modern loads.

Signs it’s time to look:

  • Lights dim when the air conditioner or oven kicks in
  • The meter box is warm, discoloured or smells hot
  • Cable insulation looks cracked or brittle where it enters the board
  • Your air conditioning or solar installer says the mains are too small

How a mains upgrade works

We start by tracing the existing cable and checking what it feeds. Then we size the new mains with headroom, because in St George the next big load is rarely far away: a granny flat out the back, a pool, or a three phase power upgrade for the new kitchen and ducted air.

On the day we lodge the notification with Ausgrid, isolate the supply and replace the cable. On a single-storey brick bungalow the new mains usually go in conduit along the same path; on a home being extended we route them to suit the new layout. Both ends are terminated, everything is tested and the power goes back on. You get a certificate of compliance for the work.

When the bracket or meter board needs to move

If you’re adding a second storey, rendering the front, or building a carport across the side driveway, the point of attachment often ends up in the wrong place. We combine the mains job with a point of attachment upgrade so it’s all done in one visit. If the overhead line itself is the problem, an overhead to underground conversion replaces the line and the mains together.

Duplex and granny flat projects

St George has more duplex and granny flat projects than almost anywhere in Sydney, especially around Hurstville, Kingsgrove and Beverly Hills. If you’re keeping the existing house and adding a dwelling, the original mains nearly always need upgrading to carry the extra load. We work with your builder and electrician early, so the mains, meter positions and network application are sorted before the slab goes down.

Get a fixed price

If your mains are original, hot or undersized, call your local level 2 electrician St George team for a free look and a fixed written price. We do this work every week, including on bungalows in level 2 electrician Bexley and Kingsgrove.

Updated

The price depends on the cable length and route, whether the meter board stays or moves, the type of wall or eave the mains run through and whether the point of attachment needs work too. You get a fixed written price after we look.

What good consumer mains upgrade looks like

Close-up of consumer mains upgrade on a home in the St George area
What consumer mains upgrade looks like up close on a typical St George area home.
Signs that consumer mains upgrade needs attention
Typical signs that it needs attention.

Consumer Mains Upgrade in St George: step by step

  1. Trace the old mainsWe follow the cable from the bracket or boundary pit to the meter board and check its size and condition.
  2. Size for your plansWe size the new mains for what you run now and what's coming, such as ducted air, an EV charger or a granny flat.
  3. Swap on the dayWe notify Ausgrid, isolate the supply, replace the mains and terminate both ends.
  4. Test and certifyWe test, reconnect and give you a certificate of compliance before we leave.

Consumer Mains Upgrade questions in St George

Something else on your mind? Call 02 9158 9911 and ask.

My bungalow still has its original meter box. Does that matter?

Often it does. Original boxes usually have the mains running up behind them through old timber, and the cable is commonly undersized or perished. We check both when we look at the job.

Can the mains be upgraded without moving the meter box?

Yes, in most cases. We only suggest moving the box if it's in a spot the rules no longer allow or it's in the way of your renovation.

How long is the power off?

Usually a few hours, and almost always the same day. We tell you the timing before we start.

Need a Level 2 electrician in St George?

📞 Call now Free quote